DKG-155

The DKG-155 is a microprocessor controlled unit designed to start and stop the genset manually using the key switch on the front panel.

In the OFF position, the DC supply is removed from the module, thus zero power consumption is achieved.

Being an Authorized Distributor of Datakom in Pakistan.
Being an DATAKOM Dealer In Pakistan.
Being an DEEP SEA Dealer In Pakistan.

DKG-317

The unit is a control and protection panel used in gensets. It shows the measured values on its
displays. The unit is designed to provide user friendliness for both the installer and the user. Programming
is usually unnecessary, as the factory settings have been carefully selected to fit most applications.
However programmable parameters allow the complete control over the generating set. Programmed
parameters are stored in a Non Volatile Memory and thus all information is retained even in the event of
complete loss of power.

DKG-309

The DKG-309 is a comprehensive AMF unit for a single genset
standby or dual genset mutual standby operations.
In AUTOMATIC position, DKG-309 monitors mains phase
voltages and controls the automatic starting, stopping and load
transfer of the generating set in case of a mains failure and
once the generator is running, it monitors internal protections
and external fault inputs. If a fault condition occurs, the unit
shuts down the engine automatically and indicates the failure
source with the corresponding red led lamp and text.

Being an Authorized Distributor of Datakom in Pakistan.
Being an DATAKOM Dealer In Pakistan.
Being an DEEP SEA Dealer In Pakistan.

DKG-307

Datakom-307 The unit is a control and protection panel used in gensets. It shows the measured values on its
displays. The unit is designed to provide user friendliness for both the installer and the user. Programming
is usually unnecessary, as the factory settings have been carefully selected to fit most applications.
However programmable parameters allow the complete control over the generating set. Programmed
parameters are stored in a Non Volatile Memory and thus all information is retained even in the event of
complete loss of power.

DKG-105

Datakom-105

The control panel is designed to provide user friendliness for both the installer and the user. Programming is usually unnecessary, as the factory settings have been carefully selected to fit most applications. However programmable parameters allow the complete control over the generating set. Programmed parameters are stored in a Non Volatile Memory and thus all information is retained even in the event of complete loss of power.