Chat With Us

All Generator Controllers

DSE-720

The DSE 720 automatic mains failure module has been primarily designed to monitor the mains
(utility) supply, starting the generator automatically should it fall out of limits, transferring the load
automatically to the generator. Once the mains (utility) has returned the load is automatically
transferred back to the mains (utility) and the generator cooled down before it stops. If required the
generator can be started and stopped manually.

DSE-704

This mode is activated by pressing the pushbutton. An LED indicator beside the button
confirms this action.
Whether the start sequence is initiated by mains (utility) failure or by remote start input, the
following sequence is followed:
To allow for short term mains supply transient conditions or false remote start signals, the Start
Delay timer is initiated. After this delay, if the pre-heat output option is selected then the pre-heat
timer is initiated, and the corresponding auxiliary output (if configured) will energise.

DSE-702

The Model 701/702 is an Engine Control Module designed to control the engine via a key switch and
pushbuttons on the front panel. The module is used to start and stop the engine and indicate fault
conditions, automatically shutting down the engine and indicating the cause of failure by LED, giving
true, first up fault annunciation.
Model 702 has integral tamperproof LCD hours run counter to indicate total engine run time.

DSE-701

To start the generator turn the key switch to the hand position, which will power up the unit.
If at this time the auxiliary input is active the led will be illuminated, preventing the start of the generator.
Pressing the pre-heat button will energise the pre-heat output. Releasing the button will de-energise the output.
Pressing the start button will energise the Fuel Solenoid output, then the Starter Motor output. The button should be pressed for the duration of the crank period.

DKG-317

The unit is a control and protection panel used in gensets. It shows the measured values on its
displays. The unit is designed to provide user friendliness for both the installer and the user. Programming
is usually unnecessary, as the factory settings have been carefully selected to fit most applications.
However programmable parameters allow the complete control over the generating set. Programmed
parameters are stored in a Non Volatile Memory and thus all information is retained even in the event of
complete loss of power.

DKG-309

The DKG-309 is a comprehensive AMF unit for a single genset
standby or dual genset mutual standby operations.
In AUTOMATIC position, DKG-309 monitors mains phase
voltages and controls the automatic starting, stopping and load
transfer of the generating set in case of a mains failure and
once the generator is running, it monitors internal protections
and external fault inputs. If a fault condition occurs, the unit
shuts down the engine automatically and indicates the failure
source with the corresponding red led lamp and text.

Being an Authorized Distributor of Datakom in Pakistan.
Being an DATAKOM Dealer In Pakistan.
Being an DEEP SEA Dealer In Pakistan.

DKG-307

Datakom-307 The unit is a control and protection panel used in gensets. It shows the measured values on its
displays. The unit is designed to provide user friendliness for both the installer and the user. Programming
is usually unnecessary, as the factory settings have been carefully selected to fit most applications.
However programmable parameters allow the complete control over the generating set. Programmed
parameters are stored in a Non Volatile Memory and thus all information is retained even in the event of
complete loss of power.

DKG-105

Datakom-105

The control panel is designed to provide user friendliness for both the installer and the user. Programming is usually unnecessary, as the factory settings have been carefully selected to fit most applications. However programmable parameters allow the complete control over the generating set. Programmed parameters are stored in a Non Volatile Memory and thus all information is retained even in the event of complete loss of power.

VR6

The K65-12B and K125-10B Voltage Regulators are contained in an
encapsulated plastic case. The regulator controls the DC exciter fi eld
power of conventional, 50 or 60 Hz brushless genera tors.